Subaru Forester Owners Forum banner
  • The "Garage" feature is for images of YOUR VEHICLE/S only - no blanks or other unrelated images please, thanks

Check engine, Eyesight, Hill start assist and Flashing "S" mode

29K views 6 replies 5 participants last post by  leehanb  
#1 ·
Need advice! This is the 3rd time the warning lights came on with in 2weeks. The 1st and 2nd time, I turned off the ignition for 10 mins or so then restart and the lights went away. This time I'm going to bring it into the dealership to see what's the problem. The car is a 2015 with exactly 9565 miles, the only mod I have is the CEM (chinese) LED DRL. I installed them last April and never any problems. Should I remove the LED before bringing the car into the dealership just in case they blame the warning lights on it or leave it be?
 
Save
#4 ·
Thanks for the input!

Update: Brought her into the dealership today with the LED strip intact (too cold and it snowed the night before). The dealership diagnosed the problem as a faulty O2 sensor that triggered all the warning lights. It's covered under warranty but the part is back-ordered for approx. two weeks.
 
Save
#5 ·
I had this happen today at end of 600 mile drive. Was going 70mph and car spontaneously slowed down and went it this mode. Took it to dealer since I was only 5 mile away and they reset and said the code had something to do with turbo and solenoid. I didn't get the code number. They basically said to bring it back if it reoccurs. Hopefully it won't.
 
#7 ·
I had the same issues with my 15Forester XT with 44K miles and it happened a couple of times only when the weather is very cold. So yesterday when it happened again, I took it to the dealership. It took them half hour to fix this. It end up being a faulty rear O2 sensor. so they just replaced it. Now it is all fine. As it was still in warranty until 50K miles, so it was all covered. I am happy this is fixed free of charge.
 
You have insufficient privileges to reply here.