[LMarshall73]

Got my windows tinted.

 

[Sandflea1]

Hauled some sod for the yard. Technically the sod was in the Old Town canoe...but pulled by the Forester so it counts! That canoe has carried firewood, appliances, furniture, lumber...and even fish. Phoebe though the sod was for her...

 

[subi4life]

today

Spent this afternoon changing out my spark plugs and fixing my radio. Apparently crutchfield neglected to tell me about connecting two wire that would boost my antenna. All fixed now! I might add that I've changed plugs on an 02 WRX, 07 STi, and now my 04 FXT and the forester was by far the hardest! Seemed like way less room than the others, and the driver side is harder than the passenger for some reason.

 

[jdh4Him]

getin' dirty for the first time...

bought a used, 02 Forester S w/ 118K miles about a week ago...

Today - changed oil & filter, air filter, and gunked-up PCV valve...

AND received my OEM manuals and used key 'fobs'...got'em programmed...good to go!

:woohoo:

 

[maelwys]

Windows tinted, moon roof tinted, moved a wooden trunk, and then drove 45 minutes to pick up my Whiteline sway bars for install this week. It was a good day.

 

[Happyclown]

Installed a set of custom Mudflaps !

 

[SubieOutlaw]

I drove from Victoria BC to Calgary in 15 hours.
Approximately 1200 km

 

[Callmedave]

I bought another 2.5Rs! Its going to be my new work vehicle.The Blue ones is my old RS my Wife has been driving it for years. The new Rs is the Black one and its a 5 speed which is soooo nice. The Blue RS is an auto which just sucks the fun out of it.

 

[ybnews]

Bought some Mobil 1 GL-5 differential fluid. Planning to do my first rear diff. oil change.
May attempt front diff. oil change next week.

 

[aCstudent]

I changed my oil - All by myself! Haven't changed my own oil in a couple of decades. The oil filter in the cars I've owned was just too hard to get at, and over time I didn't fit under my cars as easily either. The new Forester has the filter Right There on the top front of the engine, and generous ground clearance means even I can easily slide underneath to remove the drain plug. Replaced the plug with a Fumoto valve to make the next oil change even easier.

 

[Geoffoz]

I broke the panel where the tweeters are supposed to go... I guess Ill have to buy tweeters now

 

[Telemarker74]

Fitted the new RedStuff pads...

The old ones were toast!

 

[LMarshall73]

Got a box today from Amazon with air and cabin filters and a Haynes manual. Didn't bother taking the air filter out of the box - I could tell it wouldn't fit at a quick glance. Pulled the dash apart to install the cabin filter (the old one looked like a forest floor covered in old leaves and acorn hulls). New filter was awful small, so I cleaned the original one the best I could and put it back in. Then came inside and processed my return...

Also put on my subaruforester.org decal! :woohoo:

 

[MJDXT]

I got mine a set of Enkie EKM3 wheels :woohoo: , should be here by the end of the week.

 

[scubadoober]

Installed a Whiteline rear sway bar, new wheels/tires, HPS pads F/R, Subaru hp trans fill, front WRX struts/springs, and got shot down by one of the dreaded rear lower strut bolts. :icon_cry: So I'm sitting a little raked at the moment. These are the typed words of a broken man. It was such a great install day to be pooped on by one bolt.

 

[17FXT]

got her very dirty!!!

 

[dstave1]

I replaced the bulbs in my fog light and window wiper heater switch so now all my lights at night work!

I also rattle canned my mud flaps satin black and I'll be picking up some yellow stained glass spray paint so i can paint my fogs yellow!:Banane17:

 

[jesusv]

added my new emblem thanks to tussen

NICE!!!! That could be your new profile pic.

 

[Lazer]

I got mine a set of Enkie EKM3 wheels :woohoo: , should be here by the end of the week.

Make sure to post up some pics of those! Those wheels are on my short list of potentials

Today I picked up some NAPA XL exhaust hangers for my MadDad 3" cat-back that will go on in a couple weeks and then cut apart my grill with a Dremel in preparation for the mesh customization that will be going into it! Tomorrow I swap trans fluids to a 50/50 mix of Motul and Redline. It will be glorious.

 

[Nikon Guy]

Covered the windshield and front end with dead love bugs, I hate those things.