Subaru Forester Owners Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Fitted a new auto box, same model number as the old one, it's all bolted on, and located on the little pins,.
Tried to start it and it wont turn over, , starters trying, just no movement...
I've tried turning it at the pulley but it wont budge....

Any advice would be appreciated.
 

·
Registered
Joined
·
15 Posts
Discussion Starter #3
Gearbox went last tuesday, complete loss of drive, , so got a new gearbox, , only thing I can think of is the torque converter not sitting fully home, , , I've taken the box back off, , and will try again tomorrow after work.
 

·
Registered
2003 EJ20K Forester
Joined
·
326 Posts
Are the bellhousings exactly the same between old and new? Same number of teeth on the starter motors? If you have a mismatched set it obviously won't work
 

·
Registered
Joined
·
15 Posts
Discussion Starter #5
Yea, its exactly the same gearbox, the only thing I can think of is the torque converter isn't sitting right, which I'll be checking this afternoon.
 
1 - 6 of 6 Posts
Top