Subaru Forester Owners Forum banner
1 - 5 of 5 Posts

· Registered
1999 Forester S
Joined
·
30 Posts
Discussion Starter · #1 ·
Does anyone have a link to wiring diagrams for the 99 forester? I have a ATF oil temp light blinking at me on start up after doing some engine work.

I suspect there is a line pinched, grounded, broken, or sensor is damaged since the light comes on immediately after starting. I am going to try a visual inspect of wiring to see if I can find it

Any suggestions on where to look? Again, If you can show me a link to electrical diagram or point me in the right direction that would be helpful. I am a rookie.

Thanks in advance.
 

· Registered
1999 Forester S
Joined
·
30 Posts
Discussion Starter · #3 ·
Hey Ferret.

We meet again...

So what does this mean? I think it is the 2 hz interzal blinking which means the AT system is normal but why am I getting this code? What should I do?

I'll double check it tonight and get back to you.

Thanks for coming through yet again.
 

· Registered
1999 Forester S
Joined
·
30 Posts
Discussion Starter · #6 ·
I'll also check those green cables under the dash tonight. I was trying to find the fuel pump relay down there so something may have been tampered with...
 

· Registered
1999 Forester S
Joined
·
30 Posts
Discussion Starter · #7 ·
New development

Went out last night to check the DTC and the battery was completely dead. What would cause this? In connection with possible elec. problems?
 
1 - 5 of 5 Posts
Top