Hey guys,
I just swapped out my stock header for an UEL header. The oil heater line runs right up on top of the new header. Those that have done the swap, how did you protect that rubber hose? I flattened the header out as much as I could and wrapped it only in that spot. But I'm still a little worried about it melting after a while.
TIA
I just swapped out my stock header for an UEL header. The oil heater line runs right up on top of the new header. Those that have done the swap, how did you protect that rubber hose? I flattened the header out as much as I could and wrapped it only in that spot. But I'm still a little worried about it melting after a while.
TIA