Hey guys! Was just wondering if anyone had a used catback in the central Pennsylvania area? My midpipe snapped and the rest of the exhaust is pretty crusty. Lol looking for aftermarket but OEM would be okay too!
I recently had my local Subie mechanic swap my old EJ25 for a JDM EJ20 and am trying to learn a bit about the JDM EJ20 motors. I was reading it's good to replace the PCV valve every so often as they have a tendency to get gunked up and as far as I know mine has never been replaced. Looking under...
i got some ongoing issues with my 03 na ej25 manual foz.
got an idle of 600ish, but when pulling up to lights it will drop down to even 200 sometimes. Usually when hot. When lights and loads are on and turning the car will stall due to the low revs.
Cleaned IACV- responds to turning off engine...
swapped 650-dollar Impreza EJ20 non-turbo engine
Royal Purple oil changes religiously
has new timing belt and water pump
fresh ngk spark plugs
front wheel bearings redone
front tie rods replaced
OEM Suspension all the way around
Street-Rays 2" Lift (aluminum | eBay | made in...
I noticed my lovely ‘03 Forester 2.5xs had a piece hanging down the other day. After troubleshooting on here, I was able to determine that my rear sway bar snapped at the “elbow,” if you will, on the driver’s side.
I couldn’t get into any shop or dealership near me for 2 weeks, so I decided...
Okay so I crashed my 2003 Subaru Forester xt jdm busted the rad but other then that the motor is fine. 5k km before I crashed the car I got all the seals, gaskets, timing belt, coil packs, injectors replaced. The car was written off but I’ve found a cross sport same year with the same motor to...
Hi, I am new here. My name is Josh and I just recently got a manual 2003 Subaru Forester Xt imported to me. She’s wonderful however the rad needs replacement. Im looking for an oem one but i’m wondering if any NA subaru rads would fit. Any help would be appreciated!